standard weddingphone setup

standard weddingphone setup

before you start

• connect the handset to the weddingphone using the coiled lead.
• fully charge your weddingphone using the USB lead provided.
• the indicator light will show red while charging and turn off once fully charged.
• your weddingphone cannot be used while charging.

record your greeting

• make sure the handset is placed down on the weddingphone in the hung-up position.
• press and hold the button in the centre of the dial for around 6 seconds.
• the weddingphone will beep and start recording your greeting.
• when finished, release the centre button.
• your greeting will play out loud once so you can hear it exactly as guests will.
• repeat this process if you wish to replace the greeting message.

record a guest message

• pick up the handset.
• listen to the greeting.
• leave a message after the beep.
• hang up the handset to save the recording.

access your recordings

• connect the weddingphone USB lead to your computer.
• open the weddingphone folder, then open the recordings folder.
• each message is saved as a separate MP3 file.
• from here, you can listen back, copy, save or delete your messages.
• deleting files is final and cannot be undone.

indicator light guide

• off: standby or powered off
• blue: weddingphone is on and connected
• flashing blue: recording a message
• red: charging or data transfer mode
• flashing red: battery low or empty
• red and blue flashing: no SD card detected