bluetooth weddingphone setup

bluetooth weddingphone setup

before you start

• fully charge your weddingphone using the USB cable provided.
• download the weddingphone app to your iPad.
• make sure bluetooth is enabled on your device.
• your weddingphone can still work as a traditional audio guestbook without bluetooth.

connect your weddingphone

• open the weddingphone app.
• enter settings.
• tap scan and connect.
• press the centre button on your weddingphone to pair your device.
• once paired, “connected” will appear in the top right corner of the app.

set up your greeting

• on the settings screen of the app, follow the on-screen instructions to record your greeting.
• this records your greeting on the phone and automatically sets the greeting length in the app.
• if you already have a greeting set, you can fine tune the app greeting length by adjusting the number of seconds.
• you can also use the general greeting setup by holding the centre button on the phone.

enter wedding mode

• once setup is complete, exit settings.
• enter wedding mode.
• tap the weddingphone icon 5 times to enter wedding mode.
• tap the weddingphone icon 5 times again to exit wedding mode.

record a message

• pick up the handset.
• listen to the greeting message.
• after the beep, record your message.
• hang up the handset to save the recording.
• your recording will appear in the gallery section of the app.

save your recordings

• audio guestbook messages are safely stored on the SD card inside the weddingphone.
• you can access audio messages by connecting your weddingphone to a computer using the provided USB cord.
• for app video recordings, open the gallery section in the weddingphone app.
• select a video and choose export file to save it to your device.

indicator light guide

• off: standby or powered off
• blue: weddingphone is on and connected
• flashing blue: recording a message
• red: charging or data transfer mode
• flashing red: battery low or empty
• red and blue flashing: no SD card detected